K60P100M100SF2RM Datasheet, PDF (648/1809 Pages) Freescale Semiconductor, Inc – K60 Sub-Family Reference Manual

Functional Description
After a sector in EEPROM backup is full of EEPROM data records, EEPROM data
records from the sector holding the oldest data are gradually copied over to a previously-
erased EEPROM backup sector. When the sector copy completes, the EEPROM backup
sector holding the oldest data is tagged for erase.
28.4.3.4 Write endurance to FlexRAM for EEPROM
When the FlexNVM partition code is not set to full data flash, the EEPROM data set size
can be set to any of several non-zero values.
The bytes not assigned to data flash via the FlexNVM partition code are used by the
FTFL to obtain an effective endurance increase for the EEPROM data. The built-in
EEPROM record management system raises the number of program/erase cycles that can
be attained prior to device wear-out by cycling the EEPROM data through a larger
EEPROM NVM storage space.
While different partitions of the FlexNVM are available, the intention is that a single
choice for the FlexNVM partition code and EEPROM data set size is used throughout the
entire lifetime of a given application. The EEPROM endurance equation and graph
shown below assume that only one configuration is ever used.
Writes_subsystem =
EEPROM – 2 × EEESPLIT × EEESIZE
EEESPLIT × EEESIZE
× Write_efficiency × n_nvmcycd
where
• Writes_subsystem — minimum number of writes to each FlexRAM location for
subsystem (each subsystem can have different endurance)
• EEPROM — allocated FlexNVM for each EEPROM subsystem based on DEPART;
entered with Program Partition command
• EEESPLIT — FlexRAM split factor for subsystem; entered with the Program
Partition command
• EEESIZE — allocated FlexRAM based on DEPART; entered with Program Partition
command
• Write_efficiency —
• 0.25 for 8-bit writes to FlexRAM
• 0.50 for 16-bit or 32-bit writes to FlexRAM
• n_nvmcycd — data flash cycling endurance
K60 Sub-Family Reference Manual, Rev. 6, Nov 2011
648
Freescale Semiconductor, Inc.