K60P100M100SF2RM Datasheet, PDF (101/1809 Pages) Freescale Semiconductor, Inc – K60 Sub-Family Reference Manual

Chapter 3 Chip Configuration
• For devices that contain FlexNVM: 1 block of program flash consisting of 2 KB
sectors
• For devices that contain FlexNVM: 1 block of FlexNVM consisting of 2 KB sectors
• For devices that contain FlexNVM: 1 block of FlexRAM
The amounts of flash memory for the devices covered in this document are:
Device
Program
flash (KB)
Block 0 (P-
Flash)
address
range¹
FlexNVM
(KB)
MK60DN256ZV 256
LL10
MK60DX256ZV 256
LL10
MK60DN512ZV 512
LL10
0x0000_0000 – —
0x0001_FFFF
0x0000_0000 – 256
0x0003_FFFF
0x0000_0000 – —
0x0003_FFFF
Block 1
(FlexNVM/ P-
Flash)
address
range¹
FlexRAM
(KB)
0x0002_0000 – —
0x0003_FFFF
0x1000_0000 – 4
0x1003_FFFF
0x0004_0000 – —
0x0007_FFFF
FlexRAM
address
range
N/A
0x1400_0000 –
0x1400_0FFF
N/A
1. For program flash only devices: The addresses shown assume program flash swap is disabled (default configuration).
3.5.1.3 Flash Memory Size Considerations
Since this document covers devices that contain program flash only and devices that
contain program flash and FlexNVM, there are some items to consider when reading the
flash memory chapter.
• The flash memory chapter shows a mixture of information depending on the device
you are using.
• For the program flash only devices:
• Two program flash blocks are supported: program flash 1 and program flash 2.
The two blocks are contiguous in the system memory map.
• The program flash blocks support a swap feature in which the starting address of
the program flash blocks can be swapped.
• The FlexRAM is not available as EEPROM or traditional RAM. Its space is only
used for programming acceleration through the Program Section command.
• For the devices containing program flash and FlexNVM:
• Since there is only one program flash block, the program flash swap feature is
not available.
K60 Sub-Family Reference Manual, Rev. 6, Nov 2011
Freescale Semiconductor, Inc.
101