K60P100M100SF2RM Datasheet, PDF (475/1809 Pages) Freescale Semiconductor, Inc – K60 Sub-Family Reference Manual

Field
Chapter 21 Direct Memory Access Controller (eDMA)
DMA_TCDn_NBYTES_MLOFFNO field descriptions (continued)
Description
As a channel activates, the appropriate TCD contents load into the eDMA engine, and the appropriate
reads and writes perform until the minor byte transfer count has transferred. This is an indivisible
operation and cannot be halted; although, it may be stalled by using the bandwidth control field, or via
preemption. After the minor count is exhausted, the SADDR and DADDR values are written back into the
TCD memory, the major iteration count is decremented and restored to the TCD memory. If the major
iteration count is completed, additional processing is performed.
21.3.22 TCD Signed Minor Loop Offset (Minor Loop and Offset
Enabled) (DMA_TCD_NBYTES_MLOFFYES)
TCD word 2 is defined as follows if:
• Minor loop mapping is enabled (CR[EMLM] = 1) and
• Minor loop offset enabled (SMLOE or DMLOE = 1)
If minor loop mapping is enabled and SMLOE and DMLOE are cleared then refer to the
TCD_NBYTES_MLOFFNO register description.
Addresses: 4000_8000h base + 1008h offset + (32d × n), where n = 0d to 15d
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
MLOFF
W
NBYTES
Reset x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x*
* Notes:
• x = Undefined at reset.
Field
31
SMLOE
30
DMLOE
29–10
MLOFF
DMA_TCDn_NBYTES_MLOFFYES field descriptions
Source Minor Loop Offset Enable
Description
Selects whether the minor loop offset is applied to the source address upon minor loop completion.
0 The minor loop offset is not applied to the SADDR
1 The minor loop offset is applied to the SADDR
Destination Minor Loop Offset enable
Selects whether the minor loop offset is applied to the destination address upon minor loop completion.
0 The minor loop offset is not applied to the DADDR
1 The minor loop offset is applied to the DADDR
If SMLOE or DMLOE is set, this field represents a sign-extended offset applied to the source or
destination address to form the next-state value after the minor loop completes.
Table continues on the next page...
K60 Sub-Family Reference Manual, Rev. 6, Nov 2011
Freescale Semiconductor, Inc.
475