K60P100M100SF2RM Datasheet, PDF (142/1809 Pages) Freescale Semiconductor, Inc – K60 Sub-Family Reference Manual

Communication interfaces
3.9.1.5 Ethernet Doze Mode
The doze mode for the Ethernet module is the same as the wait and VLPW modes for the
chip.
3.9.1.6 Ethernet Interrupts
The Ethernet has multiple sources of interrupt requests. However, some of these sources
are OR'd together to generate an interrupt request. See below for a summary:
Interrupt request
IEEE 1588 timer interrupt
Transmit interrupt
Receive interrupt
Error and miscellaneous interrupt
Interrupt source
• Time stamp available
• 1588 timer interrupt
• Transmit frame interrupt
• Transmit buffer interrupt
• Receive frame interrupt
• Receive buffer interrupt
• Wake-up
• Payload receive error
• Babbling receive error
• Babbling transmit error
• Graceful stop complete
• MII interrupt – Data transfer done
• Ethernet bus error
• Late collision
• Collision retry limit
3.9.1.7 Ethernet event signal
The event signal output is not supported on this device. Therefore, ATCR[PINPER] has
no effect.
3.9.2 Universal Serial Bus (USB) Subsystem
The USB subsystem includes these components:
• Dual-role USB OTG-capable (On-The-Go) controller that supports a full-speed (FS)
device or FS/LS host. The module complies with the USB 2.0 specification.
• USB transceiver that includes internal 15 kΩ pulldowns on the D+ and D- lines for
host mode functionality.
• A 3.3 V regulator.
• USB device charger detection module.
• VBUS detect signal: To detect a valid VBUS in device mode, use a GPIO signal that
can wake the chip in all power modes.
K60 Sub-Family Reference Manual, Rev. 6, Nov 2011
142
Freescale Semiconductor, Inc.