K60P100M100SF2RM Datasheet, PDF (1268/1809 Pages) Freescale Semiconductor, Inc – K60 Sub-Family Reference Manual

Host Mode Operation Examples
2. Enable the ATTACH interrupt (INT_ENB[ATTACH]=1).
3. Wait for ATTACH interrupt (INT_STAT[ATTACH]). Signaled by USB Target pull-
up resistor changing the state of DPLUS or DMINUS from 0 to 1 (SE0 to J or K
state).
4. Check the state of the JSTATE and SE0 bits in the control register. If the connecting
device is low speed (JSTATE bit is 0), set the low-speed bit in the address registers
(ADDR[LS_EN]=1) and the host without hub bit in endpoint 0 register control
(EP_CTL0[HOST_WO_HUB]=1).
5. Enable RESET (CTL[RESET]=1) for 10 ms.
6. Enable SOF packet to keep the connected device from going to suspend
(CTL[USB_EN=1]).
7. Start enumeration by sending a sequence of device framework commands, device
frame work packets to the default control pipe of the connected device. Refer to the
Universal Serial Bus Revision 2.0 specification, "Chapter 9 USB Device Framework"
(http://www.usb.org/developers/docs).
To complete a control transaction to a connected device:
1. Complete all steps discover a connected device
2. Set up the endpoint control register for bidirectional control transfers EP_CTL0[4:0]
= 0x0d.
3. Place a copy of the device framework setup command in a memory buffer. Refer to
the Universal Serial Bus Revision 2.0 specification, "Chapter 9 USB Device
Framework" (http://www.usb.org/developers/docs).
4. Initialize current (even or odd) TX EP0 BDT to transfer the 8 bytes of command data
for a device framework command (for example, a GET DEVICE DESCRIPTOR).
• Set the BDT command word to 0x00080080 –Byte count to 8, own bit to 1.
• Set the BDT buffer address field to the start address of the 8 byte command
buffer.
5. Set the USB device address of the target device in the address register (ADDR[6:0]).
After the USB bus reset, the device USB address is zero. It is set to some other value
(usually 1) by the Set Address device framework command.
6. Write the token register with a SETUP to Endpoint 0 the target device default control
pipe (TOKEN=0xD0). This initiates a setup token on the bus followed by a data
packet. The device handshake is returned in the BDT PID field after the packets
1268
K60 Sub-Family Reference Manual, Rev. 6, Nov 2011
Freescale Semiconductor, Inc.