K60P100M100SF2RM Datasheet, PDF (1790/1809 Pages) Freescale Semiconductor, Inc – K60 Sub-Family Reference Manual

External signal description
56.2 External signal description
The JTAGC consists of a set of signals that connect to off chip development tools and
allow access to test support functions. The JTAGC signals are outlined in the following
table and described in the following sections.
Table 56-1. JTAG signal properties
Name
TCK
TDI
TDO
TMS
I/O
Input
Input
Output
Input
Function
Test Clock
Test Data In
Test Data Out
Test Mode Select
Reset State
—
—
High Z¹
—
Pull
Down
Up
—
Up
1. TDO output buffer enable is negated when the JTAGC is not in the Shift-IR or Shift-DR states. A weak pull may be
implemented at the TDO pad for use when JTAGC is inactive.
56.2.1 TCK—Test clock input
Test Clock Input (TCK) is an input pin used to synchronize the test logic and control
register access through the TAP.
56.2.2 TDI—Test data input
Test Data Input (TDI) is an input pin that receives serial test instructions and data. TDI is
sampled on the rising edge of TCK.
56.2.3 TDO—Test data output
Test Data Output (TDO) is an output pin that transmits serial output for test instructions
and data. TDO is three-stateable and is actively driven only in the Shift-IR and Shift-DR
states of the TAP controller state machine, which is described in TAP controller state
machine.
56.2.4 TMS—Test mode select
Test Mode Select (TMS) is an input pin used to sequence the IEEE 1149.1-2001 test
control state machine. TMS is sampled on the rising edge of TCK.
1790
K60 Sub-Family Reference Manual, Rev. 6, Nov 2011
Freescale Semiconductor, Inc.