K60P100M100SF2RM Datasheet, PDF (148/1809 Pages) Freescale Semiconductor, Inc – K60 Sub-Family Reference Manual

Communication interfaces
NOTE
When USB is not used in the application, it is recommended
that the USB regulator VREGIN and VOUT33 pins remain
floating.
3.9.3 CAN Configuration
This section summarizes how the module has been configured in the chip. For a
comprehensive description of the module itself, see the module’s dedicated chapter.
Peripheral
bridge
Register
access
FlexCAN
Module signals
Topic
Full description
System memory map
Clocking
Power management
Signal Multiplexing
Figure 3-59. CAN configuration
Table 3-66. Reference links to related information
Related module
CAN
Port control
Reference
CAN
System memory map
Clock Distribution
Power management
Signal Multiplexing
3.9.3.1 Number of FlexCAN modules
This device contains 2 identical FlexCAN modules.
3.9.3.2 Reset value of MDIS bit
The CAN_MCR[MDIS] bit is set after reset. Therefore, FlexCAN module is disabled
following a reset.
K60 Sub-Family Reference Manual, Rev. 6, Nov 2011
148
Freescale Semiconductor, Inc.