K60P100M100SF2RM Datasheet, PDF (150/1809 Pages) Freescale Semiconductor, Inc – K60 Sub-Family Reference Manual

Communication interfaces
3.9.3.6 FlexCAN Operation in Low Power Modes
The FlexCAN module is operational in VLPR and VLPW modes. With the 2 MHz bus
clock, the fastest supported FlexCAN transfer rate is 256 kbps. The bit timing parameters
in the module must be adjusted for the new frequency, but full functionality is possible.
The FlexCAN module can be configured to generate a wakeup interrupt in STOP and
VLPS modes. When the FlexCAN is configured to generate a wakeup, a recessive to
dominant transition on the CAN bus generates an interrupt.
3.9.3.7 FlexCAN Doze Mode
The Doze mode for the FlexCAN module is the same as the Wait and VLPW modes for
the chip.
3.9.4 SPI configuration
This section summarizes how the module has been configured in the chip. For a
comprehensive description of the module itself, see the module’s dedicated chapter.
Peripheral
bridge
Register
access
SPI
Module signals
Topic
Full description
System memory map
Clocking
Signal Multiplexing
Figure 3-60. SPI configuration
Table 3-67. Reference links to related information
Related module
SPI
Port control
Reference
SPI
System memory map
Clock Distribution
Signal Multiplexing
K60 Sub-Family Reference Manual, Rev. 6, Nov 2011
150
Freescale Semiconductor, Inc.