SH7205 Datasheet, PDF (991/1904 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7200 Series

Section 20 Controller Area Network (RCAN-TL1)
(3) Bit Configuration Register (BCR0, BCR1)
The bit configuration registers (BCR0 and BCR1) are 2 X 16-bit read/write register that are used
to set CAN bit timing parameters and the baud rate pre-scaler for the CAN Interface.
The Time quanta is defined as:
2 * BRP
Timequanta = _fclk
Where: BRP (Baud Rate Pre-scaler) is the value stored in BCR0 incremented by 1 and fclk is the
used peripheral bus frequency.
• BCR1 (Address = H'004)
Bit: 15 14 13 12 11 10 9
8
7
6
5
4
3
2
1
0
TSG1[3:0]
-
TSG2[2:0]
-
-
SJW[1:0]
-
-
-
BSP
Initial value: 0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
R/W: R/W R/W R/W R/W R R/W R/W R/W R
R R/W R/W R
R
R R/W
Bits 15 to 12 — Time Segment 1 (TSG1[3:0] = BCR1[15:12]): These bits are used to set the
segment TSEG1 (= PRSEG + PHSEG1) to compensate for edges on the CAN Bus with a positive
phase error. A value from 4 to 16 time quanta can be set.
Bit 15: Bit 14: Bit 13: Bit 12:
TSG1[3] TSG1[2] TSG1[1] TSG1[0] Description
0
0
0
0
Setting prohibited (Initial value)
0
0
0
1
Setting prohibited
0
0
1
0
Setting prohibited
0
0
1
1
PRSEG + PHSEG1 = 4 time quanta
0
1
0
0
PRSEG + PHSEG1 = 5 time quanta
:
:
:
:
:
:
:
:
:
:
1
1
1
1
PRSEG + PHSEG1 = 16 time quanta
Bit 11: Reserved. The written value should always be ‘0’ and the returned value is ‘0’.
Rev. 1.00 Mar. 25, 2008 Page 959 of 1868
REJ09B0372-0100