SH7764 Datasheet, PDF (1182/1752 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC Engine Family SH-4A Series

Section 23 G2D
Notes: 1. 8-point drawing is used for a line width of 1. Both of the 8-point drawing and 4-point
drawing are used for bold line drawing.
2. The final point of each line segment is drawn. When the starting and final coordinate
points of a line segment match, a single dot is drawn for a line width of 1 and nothing
is drawn for bold line drawing.
3. When AA = 1, note the following:
• For a dashed line, antialiasing is not performed for the gaps in the dashed line.
• When the starting and final coordinate points of a line segment match, antialiasing
is not performed.
• Antialiasing is not performed for horizontal, vertical, and 45-degree diagonal line
segments
4. The final coordinate point before coordinate transformation is stored as the current
pointer values (XC, YC).
Rev. 1.00 Nov. 22, 2007 Page 1126 of 1692
REJ09B0360-0100