SH7263 Datasheet, PDF (869/1862 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7260 Series

Section 17 I²C Bus Interface 3 (IIC3)
Bit
2 to 0
Initial
Bit Name Value
BC[2:0] 000
R/W Description
R/W Bit Counter
These bits specify the number of bits to be transferred
next. When read, the remaining number of transfer bits
is indicated. With the I²C bus format, the data is
transferred with one addition acknowledge bit. Should
be made between transfer frames. If these bits are set
to a value other than B'000, the setting should be made
while the SCL pin is low. The value returns to B'000 at
the end of a data transfer, including the acknowledge
bit. In addition, the value automatically returns to B'111
after the detection of a stop condition. These bits are
cleared by a power-on reset and in software standby
mode and module standby mode. These bits are also
cleared by setting the IICRST bit of ICCR2 to 1. With
the clocked synchronous serial format, these bits
should not be modified.
I²C Bus Format Clocked Synchronous Serial Format
000: 9 bits
000: 8 bits
001: 2 bits
001: 1 bit
010: 3 bits
010: 2 bits
011: 4 bits
011: 3 bits
100: 5 bits
100: 4 bits
101: 6 bits
101: 5 bits
110: 7 bits
110: 6 bits
111: 8 bits
111: 7 bits
Rev. 2.00 Mar. 14, 2008 Page 835 of 1824
REJ09B0290-0200