SH7263 Datasheet, PDF (1452/1862 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7260 Series

Section 26 LCD Controller (LCDC)
(TFT module)
State
Control Pin
Power Supply for
Logic
LCD_VCPWC
Operating State
(Transitional State)
Stopped State
Supply
Supply
Supply
Display Data,
Timing Signal
LCD_CL2, LCD_CL1,
LCD_FLM,
LCD_M_DISP,
LCD_DATA
Supply
Supply
Power Supply for
High-Voltage Systems
LCD_VEPWC
Supply
The table above shows the states of the power supply, display data, and timing signals for the
typical LCD module in its active and stopped states. Some of the supply voltages described may
not be necessary, because some modules internally generate the power supply required for high-
voltage systems from the logic-level power-supply voltage.
• Notes on display-off mode (LCDC stopped)
If LCD module power-supply control-sequence processing is in use by the LCDC or the
supply of power is cut off while the LCDC is in its display-on mode, normal operation is not
guaranteed. In the worst case, the connected LCD module may be damaged.
26.4.7 Operation for Hardware Rotation
Operation in hardware-rotation mode is described below. Hardware-rotation mode can be thought
of as using a landscape-format LCD panel instead of a portrait-format LCD panel by placing the
landscape-format LCD panel as if it were a portrait-format panel. Whether the panel is intended
for use in landscape or portrait format is thus no problem. The panel must, however, be within 320
pixels wide.
When making settings for hardware rotation, the following five differences from the setting for no
hardware rotation must be noted. (The following example is for a display at 8 bpp. At 16 bpp, the
amount of memory per dot will be doubled. The image size and register values used for rotation
will thus be different.)
Rev. 2.00 Mar. 14, 2008 Page 1418 of 1824
REJ09B0290-0200