SH7263 Datasheet, PDF (1379/1862 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7260 Series

Section 25 USB 2.0 Host/Function Module (USB)
25.4.5 Control Transfers (DCP)
Data transfers of the data stage of control transfers are done using the default control pipe (DCP).
The DCP buffer memory is a 256-byte single buffer, and is a fixed area that is shared for both
control reading and control writing. The buffer memory can be accessed through the CFIFO port.
(1) Control Transfers when the Host Controller Function is Selected
(a) Setup Stage
USQREQ, USBVAL, USBINDX, and USBLENG are the registers that are used to transmit a USB
request for setup transactions. Writing setup packet data to the registers and writing 1 to the
SUREQ bit in DCPCTR transmits the specified data for setup transactions. Upon completion of
transactions, the SUREQ bit is cleared to 0. The above USB request registers should not be
modified while SUREQ = 1. The device address for setup transactions is specified using the
DEVSEL bits in DCPMAXP.
When the data for setup transactions has been sent, a SIGN or SACK interrupt request is generated
according to the response received from the peripheral side (SIGN1 or SACK bits in INTSTS1),
by means of which the result of the setup transactions can be confirmed.
A data packet of DATA0 (USB request) is transmitted as the data packet for the setup transactions
regardless of the setting of the SQMON bit in DCPCTR.
(b) Data Stage
Data transfers are done using the DCP buffer memory.
The access direction of the DCP buffer memory should be specified using the ISEL bit in
CFIFOSEL.
For the first data packet of the data stage, the data PID must be transferred as DATA1. Transaction
is done by setting the data PID = DATA1 and the PID bit = BUF using the SQSET bit in
DCPCFG. Completion of data transfer is detected using the BRDY and BEMP interrupts.
Setting continuous transfer mode allows data transfers over multiple packets. Note that when
continuous transfer mode is set for the receiving direction, the BRDY interrupt is not generated
until the buffer becomes full or a short packet is received (the integer multiple of the maximum
packet size, and less than 256 bytes).
For control write transfers, when the number of data bytes to be sent is the integer multiple of the
maximum packet size, software must control so as to send a zero-length packet at the end.
Rev. 2.00 Mar. 14, 2008 Page 1345 of 1824
REJ09B0290-0200