SH7263 Datasheet, PDF (237/1862 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7260 Series

Section 7 User Break Controller (UBC)
⎯ When a break condition is specified for the I bus, only the data access cycle is monitored.
The instruction fetch cycle (including the cache renewal cycle) is not monitored.
⎯ Only data access cycles are issued for the internal DMA bus cycles.
⎯ If a break condition is specified for the I bus, even when the condition matches in an
internal CPU bus cycle resulting from an instruction executed by the CPU, at which
instruction the user break interrupt request is to be accepted cannot be clearly defined.
7.4.2 Break on Instruction Fetch Cycle
1. When C bus/instruction fetch/read/word or longword is set in the break bus cycle register
(BBR), the break condition is the FAB bus instruction fetch cycle. Whether a start of user
break interrupt exception processing is set before or after the execution of the instruction can
then be selected with the PCB0 or PCB1 bit of the break control register (BRCR) for the
appropriate channel. If an instruction fetch cycle is set as a break condition, clear BA0 bit in
the break address register (BAR) to 0. A break cannot be generated as long as this bit is set to
1.
2. A break for instruction fetch which is set as a break before instruction execution occurs when it
is confirmed that the instruction has been fetched and will be executed. This means a break
does not occur for instructions fetched by overrun (instructions fetched at a branch or during
an interrupt transition, but not to be executed). When this kind of break is set for the delay slot
of a delayed branch instruction, the user break interrupt request is not received until the
execution of the first instruction at the branch destination.
Note: If a branch does not occur at a delayed branch instruction, the subsequent instruction is
not recognized as a delay slot.
3. When setting a break condition for break after instruction execution, the instruction set with
the break condition is executed and then the break is generated prior to execution of the next
instruction. As with pre-execution breaks, a break does not occur with overrun fetch
instructions. When this kind of break is set for a delayed branch instruction and its delay slot,
the user break interrupt request is not received until the first instruction at the branch
destination.
4. When an instruction fetch cycle is set, the break data register (BDR) is ignored. Therefore,
break data cannot be set for the break of the instruction fetch cycle.
5. If the I bus is set for a break of an instruction fetch cycle, the setting is invalidated.
Rev. 2.00 Mar. 14, 2008 Page 203 of 1824
REJ09B0290-0200