SH7263 Datasheet, PDF (238/1862 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7260 Series

Section 7 User Break Controller (UBC)
7.4.3 Break on Data Access Cycle
1. If the C bus is specified as a break condition for data access break, condition comparison is
performed for the addresses (and data) accessed by the executed instructions, and a break
occurs if the condition is satisfied. If the I bus is specified as a break condition, condition
comparison is performed for the addresses (and data) of the data access cycles on the bus
specified by the I bus select bits, and a break occurs if the condition is satisfied. For details on
the CPU bus cycles issued on the internal CPU bus, see 6 in section 7.4.1, Flow of the User
Break Operation.
2. The relationship between the data access cycle address and the comparison condition for each
operand size is listed in table 7.3.
Table 7.3 Data Access Cycle Addresses and Operand Size Comparison Conditions
Access Size
Longword
Word
Byte
Address Compared
Compares break address register bits 31 to 2 to address bus bits 31 to 2
Compares break address register bits 31 to 1 to address bus bits 31 to 1
Compares break address register bits 31 to 0 to address bus bits 31 to 0
This means that when address H'00001003 is set in the break address register (BAR), for
example, the bus cycle in which the break condition is satisfied is as follows (where other
conditions are met).
Longword access at H'00001000
Word access at H'00001002
Byte access at H'00001003
3. When the data value is included in the break conditions:
When the data value is included in the break conditions, either longword, word, or byte is
specified as the operand size in the break bus cycle register (BBR). When data values are
included in break conditions, a break is generated when the address conditions and data
conditions both match. To specify byte data for this case, set the same data in the four bytes at
bits 31 to 24, 23 to 16, 15 to 8, and 7 to 0 of the break data register (BDR) and break data mask
register (BDMR). To specify word data for this case, set the same data in the two words at bits
31 to 16 and 15 to 0.
4. Access by a PREF instruction is handled as read access in longword units without access data.
Therefore, if including the value of the data bus when a PREF instruction is specified as a
break condition, a break will not occur.
5. If the data access cycle is selected, the instruction at which the break will occur cannot be
determined.
Rev. 2.00 Mar. 14, 2008 Page 204 of 1824
REJ09B0290-0200