SH7263 Datasheet, PDF (849/1862 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7260 Series

Section 16 Synchronous Serial Communication Unit (SSU)
16.4.7 Clock Synchronous Communication Mode
In clock synchronous communication mode, data communications are performed via three lines:
clock line (SSCK), data input line (SSI), and data output line (SSO).
(1) Initial Settings in Clock Synchronous Communication Mode
Figure 16.12 shows an example of the initial settings in clock synchronous communication mode.
Before data transfer, clear both the TE and RE bits in SSER to 0 to set the initial values.
Note:
Before changing operating modes and communications formats, clear both the TE and RE
bits to 0. Although clearing the TE bit to 0 sets the TDRE bit to 1, clearing the RE bit to 0
does not change the values of the RDRF and ORER bits and SSRDR. Those bits retain the
previous values.
Start setting initial values
Clear the TE and RE bits in SSER to 0
[1] Set PFC for external pins to be used
(SSCK, SSI, SSO, and SCS)
[2]
Specify the MSS bit in SSCRH
[3] ^{Set the SSUMS bit in SSCRL to 1 and}
specify bits DATS1 and DATS0
[1] Make appropriate settings in the PFC for the external
pins to be used.
[2] Specify master/slave mode selection and SSCK pin
selection.
[3] Selects clock synchronous communication mode and
specify transmit/receive data length.
[4] Specify clock polarity selection and transfer clock rate
selection.
[5] Enables/disables interrupt request to the CPU.
[4] ^{Specify the CPOS, CKS2, CKS1, and}
CKS0 bits in SSMR
[5]
Specify the TEIE, TIE, RIE, TE, RE
and CEIE bits in SSER all together
End
Figure 16.12 Example of Initial Settings in Clock Synchronous Communication Mode
Rev. 2.00 Mar. 14, 2008 Page 815 of 1824
REJ09B0290-0200