English
Language : 

SH7760 Datasheet, PDF (827/1345 Pages) Renesas Technology Corp – SuperHTM RISC engine
Ch. Register Name
Abbrev.
Power-on
Reset by
RESET
Pin/WDT/
H-UDI
Manual Reset
Standby
by RESET
Sleep
by
Pin/WDT/
by Sleep
Software/
Multiple
Instruction/ by
Each
Exception
Deep Sleep Hardware Module
1 Mailbox 14
CAN1MB14 Undefined Undefined
Retained
* Retained
Mailbox 15
CAN1MB15 Undefined Undefined
Retained
Retained
Mailbox 16
CAN1MB16 Undefined Undefined
Retained
Retained
Mailbox 17
CAN1MB17 Undefined Undefined
Retained
Retained
Mailbox 18
CAN1MB18 Undefined Undefined
Retained
Retained
Mailbox 19
CAN1MB19 Undefined Undefined
Retained
Retained
Mailbox 20
CAN1MB20 Undefined Undefined
Retained
Retained
Mailbox 21
CAN1MB21 Undefined Undefined
Retained
Retained
Mailbox 22
CAN1MB22 Undefined Undefined
Retained
Retained
Mailbox 23
CAN1MB23 Undefined Undefined
Retained
Retained
Mailbox 24
CAN1MB24 Undefined Undefined
Retained
Retained
Mailbox 25
CAN1MB25 Undefined Undefined
Retained
Retained
Mailbox 26
CAN1MB26 Undefined Undefined
Retained
Retained
Mailbox 27
CAN1MB27 Undefined Undefined
Retained
Retained
Mailbox 28
CAN1MB28 Undefined Undefined
Retained
Retained
Mailbox 29
CAN1MB29 Undefined Undefined
Retained
Retained
Mailbox 30
CAN1MB30 Undefined Undefined
Retained
Retained
Mailbox 31
CAN1MB31 Undefined Undefined
Retained
Retained
Notes: * After exiting hardware standby mode, this LSI enters the Power-On Reset state by the
RESET pin.
*1. Can be written to when MCR15 = MCR = 1 (Test Mode).
*2. Only allows writing a 1 to the Mailbox designated for transmission.
*3. Cannot be modified.
*4. The Message Control, Message Data, Timestamp and LAFM fields can only be
accessed with 16 bits, whereas the Message Data area can be accessed with 16 bits or
8 bits. Also, unused parts of Mailboxes must be initialized during the configuration to
their inactive state as they are configured of RAM.
*5. Unused Mailboxes can be used as memory. However, it is important in such case to
disable the related mailbox (setting MBC to B’111) in order to avoid that the mailbox
joins the search for a matching identifier during the reception of messages, and even
store a wrong message in the worst case.
Rev. 1.0, 02/03, page 777 of 1294