PXR40RM Datasheet, PDF (733/1434 Pages) Freescale Semiconductor, Inc – PXR40 Microcontroller

FlexRay Communication Controller (FLEXRAY)
Table 22-117. FlexRay Channel Bit Rate Control
FlexRay Channel
Bit Rate
[Mbit/s]
MCR.BITRATE
10.0
000
25.0
12.5
2
8
5
8.0
011
25.0
12.5
2
10
6
5.0
001
25.0
25.0
1
8
5
2.5
010
50.0
50.0
1
8
5
NOTE
The bit rate of 8 Mbit/s is not defined by the FlexRay Communications
System Protocol Specification, Version 2.1 Rev A.
22.7 Application Information
22.7.1 Initialization Sequence
This section describes the required steps to initialize the controller. The first subsection describes the steps
required after a system reset, the second section describes the steps required after preceding shutdown of
the controller.
22.7.1.1 Module Initialization
This section describes the module related initialization steps after a system reset.
1. Configure controller.
a) configure the control bits in the Module Configuration Register (MCR)
b) configure the system memory base address in System Memory Base Address Register
(SYMBADR)
2. Enable the controller.
a) write 1 to the module enable bit MEN in the Module Configuration Register (MCR)
The controller now enters the Normal Mode. The application can commence with the protocol
initialization described in Section 22.7.1.2, Protocol Initialization.
Freescale Semiconductor
PXR40 Microcontroller Reference Manual, Rev. 1
22-149