PXS20RM Datasheet, PDF (702/1368 Pages) Freescale Semiconductor, Inc – PXS20 Microcontroller

Flexible Motor Control Pulse Width Modulator Module (FlexPWM)
NOTE
These bits are double buffered and do not take effect until a FORCE_OUT
event occurs within the appropriate submodule. Refer to Figure 25-17 to
see how FORCE_OUT is generated. Reading these bits reads the buffered
value and not necessarily the value currently in effect.
OUT23_3 - Software Controlled Output 23_3
This bit is only used when SEL23 for submodule 3 is set to 0b10. It allows software control of which
signal is supplied to the deadtime generator of that submodule.
1 = A logic 1 is supplied to the deadtime generator of submodule 3 instead of PWM23.
0 = A logic 0 is supplied to the deadtime generator of submodule 3 instead of PWM23.
OUT45_3 - Software Controlled Output 45_3
This bit is only used when SEL45 for submodule 3 is set to 0b10. It allows software control of which
signal is supplied to the deadtime generator of that submodule.
1 = A logic 1 is supplied to the deadtime generator of submodule 3 instead of PWM45.
0 = A logic 0 is supplied to the deadtime generator of submodule 3 instead of PWM45.
OUT23_2 - Software Controlled Output 23_2
This bit is only used when SEL23 for submodule 2 is set to 0b10. It allows software control of which
signal is supplied to the deadtime generator of that submodule.
1 = A logic 1 is supplied to the deadtime generator of submodule 2 instead of PWM23.
0 = A logic 0 is supplied to the deadtime generator of submodule 2 instead of PWM23.
OUT45_2 - Software Controlled Output 45_2
This bit is only used when SEL45 for submodule 2 is set to 0b10. It allows software control of which
signal is supplied to the deadtime generator of that submodule.
1 = A logic 1 is supplied to the deadtime generator of submodule 2 instead of PWM45.
0 = A logic 0 is supplied to the deadtime generator of submodule 2 instead of PWM45.
OUT23_1 - Software Controlled Output 23_1
This bit is only used when SEL23 for submodule 1 is set to 0b10. It allows software control of which
signal is supplied to the deadtime generator of that submodule.
1 = A logic 1 is supplied to the deadtime generator of submodule 1 instead of PWM23.
0 = A logic 0 is supplied to the deadtime generator of submodule 1 instead of PWM23.
OUT45_1 - Software Controlled Output 45_1
This bit is only used when SEL45 for submodule 1 is set to 0b10. It allows software control of which
signal is supplied to the deadtime generator of that submodule.
1 = A logic 1 is supplied to the deadtime generator of submodule 1 instead of PWM45.
0 = A logic 0 is supplied to the deadtime generator of submodule 1 instead of PWM45.
OUT23_0 - Software Controlled Output 23_0
This bit is only used when SEL23 for submodule 0 is set to 0b10. It allows software control of which
signal is supplied to the deadtime generator of that submodule.
25-56
PXS20 Microcontroller Reference Manual, Rev. 1
Freescale Semiconductor