SH7261 Datasheet, PDF (876/1348 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7260 Series

Section 19 Controller Area Network (RCAN-ET) [R5S72611] [R5S72613]
19.4.6 Transmit Error Counter (TEC) and Receive Error Counter (REC)
The Transmit Error Counter (TEC) and Receive Error Counter (REC) is a 16-bit read/(write)
register that functions as a counter indicating the number of transmit/receive message errors on the
CAN Interface. The count value is stipulated in the CAN protocol specification Refs. [2], [3], [4]
and [5]. When not in (Write Error Counter) test mode this register is read only, and can only be
modified by the CAN Interface. This register can be cleared by a Reset request (MCR0) or
entering to bus off.
In Write Error Counter test mode (i.e. TST[2:0] = B'100), it is possible to write to this register.
The same value can only be written to TEC/REC, and the value written into TEC is set to TEC
and REC. When writing to this register, RCAN-ET needs to be put into Halt Mode. This feature is
only intended for test purposes.
• TEC/REC (Address = H'00C)
Bit: 15 14 13 12 11 10 9
8
7
6
5
4
3
2
1
0
TEC7 TEC6 TEC5 TEC4 TEC3 TEC2 TEC1 TEC0 REC7 REC6 REC5 REC4 REC3 REC2 REC1 REC0
Initial value: 0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
R/W: R/W* R/W* R/W* R/W* R/W* R/W* R/W* R/W* R/W* R/W* R/W* R/W* R/W* R/W* R/W* R/W*
Note: * It is only possible to write the value in test mode when TST[2:0] in MCR is B'100.
REC is incremented during Bus Off to count the recurrences of 11 recessive bits as
requested by the Bus Off recovery sequence.
Rev. 2.00 Sep. 07, 2007 Page 844 of 1312
REJ09B0320-0200