SH7261 Datasheet, PDF (538/1348 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7260 Series

Section 12 Multi-Function Timer Pulse Unit 2 (MTU2)
(i) Initial Output in Complementary PWM Mode
In complementary PWM mode, the initial output is determined by the setting of bits OLSN and
OLSP in timer output control register 1 (TOCR1) or bits OLS1N to OLS3N and OLS1P to OLS3P
in timer output control register 2 (TOCR2).
This initial output is the PWM pulse non-active level, and is output from when complementary
PWM mode is set with the timer mode register (TMDR) until TCNT_4 exceeds the value set in
the dead time register (TDDR). Figure 12.44 shows an example of the initial output in
complementary PWM mode.
An example of the waveform when the initial PWM duty value is smaller than the TDDR value is
shown in figure 12.45.
Timer output control register settings
OLSN bit: 0 (initial output: high; active level: low)
OLSP bit: 0 (initial output: high; active level: low)
TCNT_3 and TCNT_4 values
TGRA_4
TCNT_3
TCNT_4
Positive phase
output
Negative phase
output
TDDR
Initial output
Dead time
Active level
Active level
Time
Complementary
PWM mode
(TMDR setting)
TCNT_3 and TCNT_4 count start
(TSTR setting)
Figure 12.44 Example of Initial Output in Complementary PWM Mode (1)
Rev. 2.00 Sep. 07, 2007 Page 506 of 1312
REJ09B0320-0200