82NM10 Datasheet, PDF (195/671 Pages) Intel Corporation – Intel® NM10 Family Express Chipset

Functional Description
Debug software can determine the current ‘initialized’ state of the EHCI by examining
the Configure Flag in the EHCI USB 2.0 Command Register. If this flag is set, then
system software has initialized the EHCI. Otherwise the EHCI should not be considered
initialized. Debug software will initialize the debug port registers depending on the
state the EHCI. However, before this can be accomplished, debug software must
determine which root USB port is designated as the debug port.
Determining the Debug Port
Debug software can easily determine which USB root port has been designated as the
debug port by examining bits 20:23 of the EHCI Host Controller Structural Parameters
register. This 4-bit field represents the numeric value assigned to the debug port (i.e.,
0001=port 0).
Debug Software Startup with Non-Initialized EHCI
Debug software can attempt to use the debug port if after setting the OWNER_CNT bit,
the Current Connect Status bit in the appropriate (See Determining the Debug Port)
PORTSC register is set. If the Current Connect Status bit is not set, then debug
software may choose to terminate or it may choose to wait until a device is connected.
If a device is connected to the port, then debug software must reset/enable the port.
Debug software does this by setting and then clearing the Port Reset bit the PORTSC
register. To ensure a successful reset, debug software should wait at least 50 ms before
clearing the Port Reset bit. Due to possible delays, this bit may not change to 0
immediately; reset is complete when this bit reads as 0. Software must not continue
until this bit reads 0.
If a high-speed device is attached, the EHCI will automatically set the Port Enabled/
Disabled bit in the PORTSC register and the debug software can proceed. Debug
software should set the ENABLED_CNT bit in the Debug Port Control/Status register,
and then reset (clear) the Port Enabled/Disabled bit in the PORTSC register (so that the
system host controller driver does not see an enabled port when it is first loaded).
Debug Software Startup with Initialized EHCI
Debug software can attempt to use the debug port if the Current Connect Status bit in
the appropriate (See Determining the Debug Port) PORTSC register is set. If the
Current Connect Status bit is not set, then debug software may choose to terminate or
it may choose to wait until a device is connected.
If a device is connected, then debug software must set the OWNER_CNT bit and then
the ENABLED_CNT bit in the Debug Port Control/Status register.
Determining Debug Peripheral Presence
After enabling the debug port functionality, debug software can determine if a debug
peripheral is attached by attempting to send data to the debug peripheral. If all
attempts result in an error (Exception bits in the Debug Port Control/Status register
Datasheet
195