PXD20RM Datasheet, PDF (1548/1628 Pages) Freescale Semiconductor, Inc – PXD20 Microcontroller

46.6 Initialization/application information
46.6.1 TCON Initialization
The procedure to bring up the TCON out of reset state and start data and timing signal generation:
1. Program TCON_COMPx and TCON_COMPx_MSK registers to configure the comparator.
2. Program TCON_PULSEx and TCON_PULSEx_MSK registers to configure the pulse generator.
3. Program TCON_SMXx and TCON_LUTx registers if necessary.
4. Program TCON_BMC (see Section 46.3.3.2, Bit Mapping Control (TCON_BMC)) register to
configure the bit mapping control.
5. Program the TCON_CTRL1 (see Section 46.3.3.1, Control Register 1 (TCON_CTRL1)) register
to configure the operation mode of TCON and enable TCON (It’s recommended to do this in two
steps, and set TCON_EN in the second).
46-40
PXD20 Microcontroller Reference Manual, Rev. 1
Preliminary—Subject to Change Without Notice
Freescale Semiconductor