SH7730 Datasheet, PDF (330/1188 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7780 Series

Section 11 Bus State Controller (BSC)
11.3 Area Overview
11.3.1 Area Division
In the architecture of this LSI, both virtual spaces and physical spaces have 32-bit address spaces.
The upper three bits divide into the P0 to P4 areas, and specify the cache access method. For
details see section 8, Caches. The remaining 29 bits are used for division of the space into ten
areas (address map 1), nine areas (address map 3), or eight areas (address map 2) according to the
MAP bit in CMNCR setting. The BSC performs control for this 29-bit space.
As listed in tables 11.2 and 11.4, this LSI can be connected directly to eight, seven, or six physical
space areas of memory, and it outputs chip select signals (CS0, CS2 to CS4, CS5A, CS5B, CS6A,
and CS6B) for each of them. CS0 is asserted during area 0 access; CS5A is asserted during area
5A access when address map 1 is selected; and CS5B is asserted when address map 2 is selected.
11.3.2 Shadow Area
Areas 0, 2 to 4, 5A, 5B, 6A, and 6B are decoded by physical addresses A28 to A25, which
correspond to areas 000 to 111. Address bits 31 to 29 are ignored. This means that the range of
area 0 addresses, for example, is H'00000000 to H'03FFFFFF, and its corresponding shadow space
is the address space in P1 to P3 areas obtained by adding to it H'20000000 × n (n = 1 to 6).
The address range for area 7 is H'1C000000 to H'1FFFFFFF. The address space H'1C000000 +
H'20000000 × n to H'1FFFFFFF + H'20000000 × n (n = 0 to 6) corresponding to the area 7
shadow space is reserved, so do not use it.
Area P4 (H'E0000000 to H'EFFFFFFF) is an I/O area and is assigned for internal register
addresses. Therefore, area P4 does not become shadow space.
Rev. 1.00 Sep. 19, 2007 Page 282 of 1136
REJ09B0359-0100