PXD10RM Datasheet, PDF (849/1332 Pages) Freescale Semiconductor, Inc – PXD10 Microcontroller

23.7.2.4 LIN error status register (LINESR)
Address: Base + 0x000C
Access: User read/write
0
1
2
3
4
5
6
7
8
9
10 11
12 13
14 15
R0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
R SZF OCF BEF CEF SFEF BDEF IDPEF FEF BOF 0 0 0 0 0 0 NF
W w1c w1c w1c w1c w1c w1c w1c w1c w1c
w1c
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Figure 23-10. LIN error status register (LINESR)
Table 23-9. LINESR field descriptions
Field
0:15
SZF
16
OCF
17
BEF
18
CEF
19
SFEF
20
BDEF
21
Description
Reserved
Stuck at Zero Flag
This bit is set by hardware when the bus is dominant for more than a 100-bit time. If the dominant
state continues, SZF flag is set again after 87-bit time. It is cleared by software.
Output Compare Flag
0 No output compare event occurred
1 The content of the counter has matched the content of OC1[0:7] or OC2[0:7] in LINOCR. If this
bit is set and IOT bit in LINTCSR is set, LINFlex moves to Idle state.
If LTOM bit in LINTCSR is set, then OCF is cleared by hardware in Initialization mode. If LTOM bit is
cleared, then OCF maintains its status whatever the mode is.
Bit Error Flag
This bit is set by hardware and indicates to the software that LINFlex has detected a bit error. This
error can occur during response field transmission (Slave and Master modes) or during header
transmission (in Master mode).
This bit is cleared by software.
Checksum Error Flag
This bit is set by hardware and indicates that the received checksum does not match the hardware
calculated checksum.
This bit is cleared by software.
Note: This bit is never set if CCD or CFD bit in LINCR1 is set.
Synch Field Error Flag
This bit is set by hardware and indicates that a Synch Field error occurred (inconsistent Synch Field).
Break Delimiter Error Flag
This bit is set by hardware and indicates that the received Break Delimiter is too short (less than one
bit time).
Freescale Semiconductor
PXD10 Microcontroller Reference Manual, Rev. 1
Preliminary—Subject to Change Without Notice
23-17