English
Language : 

PXD10RM Datasheet, PDF (1043/1332 Pages) Freescale Semiconductor, Inc – PXD10 Microcontroller
Address: QSPI_AMBA_BASE + 0x07FF FFFC
0
1
2
3
4
5
R
W
Reset 0 0 0 0 0 0
6
7
8
9
ARXD[31:16]
0000
10 11 12 13 14 15
000000
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
R
ARXD[15:0]
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Figure 30-22. AHB RX Data Buffer (QSPI_ARDB)
Table 30-36. QSPI_ARDB Field Descriptions
Field
ARXD
Description
AMBA provided RX Buffer Data.
Byte order (endianess) is identical to the RX Buffer Data Registers.
30.5 Functional Description
The Quad Serial Peripheral Interface (QuadSPI) block can be used for two different types (mutually
exclusive) of serial communications:
• It supports standard SPI full-duplex, synchronous serial communications with peripheral devices.
• It acts as an interface to external serial flash devices via up to 4 bidirectional data lines.
30.5.1 Modes of Operation
Refer to Section 30.2.3, QuadSPI modes of operation for an overview over the possible operational modes
of the QuadSPI block.
• SPI Master Mode: In Master Mode the QuadSPI can initiate SPI communications with peripheral
devices. See Section 30.5.2.2, Master Mode,” for more details.
• SPI Slave Mode: In Slave Mode the QuadSPI responds to SPI transfers initiated by an external SPI
master. SeeSection 30.5.2.3, Slave Mode.” for more details.
• Serial Flash Mode can be used for write or read accesses to an external serial flash device.
— Serial Flash Write: Data can be programmed into the flash of the serial flash device. Refer to
Section 30.5.3.2, Flash Programming” for further details.
— Serial Flash Read: Read the contents of the serial flash device. Two separate read channels are
available via RX Buffer and AHB Buffer, see Section 30.5.3.3, Flash Read”.
• Stop Mode: The mode is used for power management. When a request is made to enter Stop Mode,
the QuadSPI block acknowledges the request and completes the transfer in progress, then the
system clocks to the QuadSPI block may be shut off, see Section 30.5.4.1, Stop Mode.
Freescale Semiconductor
PXD10 Microcontroller Reference Manual, Rev. 1
Preliminary—Subject to Change Without Notice
30-39