PXD10RM Datasheet, PDF (761/1332 Pages) Freescale Semiconductor, Inc – PXD10 Microcontroller

The interrupt acknowledge register provides a value that can be used to load the address of an ISR from a
vector table. The vector table can be composed of addresses of the ISRs specific to their respective
interrupt vectors.
In software vector mode, the INTC_IACKR has side effects from reads. Therefore, it must not be
speculatively read while in this mode. The side effects are the same regardless of the size of the read.
Reading the INTC_IACKR does not have side effects in hardware vector mode.
21.5.2.4 INTC End-of-Interrupt Register (INTC_EOIR)
Offset 0x0018
Access: write only
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
R_{0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0}
W
Reset _{0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0}
Figure 21-5. INTC End-of-Interrupt Register (INTC_EOIR)
Writing to the end-of-interrupt register signals the end of the servicing of the interrupt request. When the
INTC_EOIR is written, the priority last pushed on the LIFO is popped into INTC_CPR. An exception to
this behavior is described in Section 21.4.1.2, Hardware Vector Mode.” The values and size of data written
to the INTC_EOIR are ignored. The values and sizes written to this register neither update the
INTC_EOIR contents or affect whether the LIFO pops. For possible future compatibility, write four bytes
of all 0s to the INTC_EOIR.
Reading the INTC_EOIR has no effect on the LIFO.
21.5.2.5 INTC Software Set/Clear Interrupt Registers
(INTC_SSCIR0_3–INTC_SSCIR4_7)
Offset: 0x0020
Access: User read/write
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
R₀
0
0
0
0
0
0 CLR0 0
0
0
0
0
0
0 CLR1
W
SET0
SET1
Reset ₀
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
R
W
Reset
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
0
0
0
0
0
0
0 CLR2 0
0
0
0
0
0
0 CLR3
SET2
SET3
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Figure 21-6. INTC Software Set/Clear Interrupt Register 0–3 (INTC_SSCIR[0:3])
Freescale Semiconductor
PXD10 Microcontroller Reference Manual, Rev. 1
Preliminary—Subject to Change Without Notice
21-9