English
Language : 

SH7059 Datasheet, PDF (927/1042 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer
29. Electrical Characteristics
[Operating precautions]
1. When the A/D converter is not used (including during standby), do not leave the AVCC, AVref, and AVSS pins open.
2. The current consumption is measured when VIHmin = VCC – 0.3 V/PVCC – 0.3 V, VIL = 0.3 V, with all output pins
unloaded.
3. The guaranteed operating range of power supply PVCC1 in the MCU expanded modes is only PVCC1 = 3.3 V ±0.3 V. Do
not use a voltage outside this range.
4. The guaranteed operating range of power supply PVCC1 in MCU single-chip mode is only PVCC1 = 5.0 V ±0.5 V. Do
not use a voltage outside this range.
Table 29.5 Permitted Output Current Values
Conditions: VCC = PLLVCC = 3.3 V ±0.3 V, PVCC1 = 5.0 V ±0.5 V/3.3 V ±0.3 V,
PVCC2 = 5.0 V ±0.5 V, AVCC = 5.0 V ±0.5 V, AVref = 4.5V to AVCC,
VSS = PLLVSS = AVSS = 0 V, Ta = –40°C to 125°C.
When PVCC1 = 3.3 V ±0.3 V, VCC = PVCC1.
When writing or erasing on-chip flash memory, Ta = –40°C to 85°C.
Item
Symbol
Min
Typ
Max
Unit
Output low-level permissible current I
OL
(per pin)
—
—
6.0
mA
Output low-level permissible current Σ IOL
—
—
80
mA
(total)
Output high-level permissible current IOH
(per pin)
—
—
2.0
mA
Output high-level permissible current Σ IOL
—
—
25
mA
(total)
[Operating precautions]
To assure LSI reliability, do not exceed the output values listed in this table.
29.3 AC Characteristics
29.3.1 Timing for swicthing the power supply on/off
Table 29.6 Timing for swicthing the power supply on/off
Conditions: VCC = PLLVCC = 3.3 V ±0.3 V, PVCC1 = 5.0 V ±0.5 V/3.3 V ±0.3 V,
PVCC2 = 5.0 V ±0.5 V, AVCC = 5.0 V ±0.5 V, AVref = 4.5 V to AVCC,
VSS = PLLVSS = AVSS = 0 V, Ta = –40°C to 125°C.
When PVCC1 = 3.3 V ±0.3 V, VCC = PVCC1.
When writing or erasing on-chip flash memory, Ta = –40°C to 85°C.
Item
Symbol
Min
Max
Time taken to switch V on
CC
t
0
—
VCCS
V hold-time when PV is swtched off
t
0
—
CC
CC
VCCH
Unit
Figures
ms
Figure 29.1
ms
Rev.3.00 Mar. 12, 2008 Page 837 of 948
REJ09B0177-0300