SH7059 Datasheet, PDF (915/1042 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer

29. Electrical Characteristics
Section 29 Electrical Characteristics
29.1 Absolute Maximum Ratings
Table 29.1 shows the absolute maximum ratings.
Table 29.1 Absolute Maximum Ratings
Item
Power
supply
voltage*
V_CC and PLLV_CC
pins
Symbol
V_CC
Rating
–0.3 to +4.3
Unit
V
PV_CC1 and
PV_CC2 pins
PV
CC
–0.3 to + 6.5
V
Input voltage EXTAL and
Vin
H-UDI pins
All pins other than Vin
analog input,
EXTAL, PLLCAP,
and H-UDI pins
PLLCAP pin
Vin
Analog supply voltage
Analog reference voltage
AV
CC
AVref
Analog input voltage
V_AN
Operating temperature (except Topr
writing or erasing flash memory)
Operating temperature (writing or TWEopr
erasing flash memory)
Storage temperature
Tstg
–0.3 to V_CC + 0.3
V
–0.3 to PV_CC + 0.3
V
–0.3 to + 2.1
V
–0.3 to +7.0
V
–0.3 to AV_CC + 0.3
V
–0.3 to AV_CC + 0.3
V
–40 to + 125
°C
–40 to +85
°C
–55 to +125
°C
Remarks
The EXTAL, XTAL, CK, and
H-UDI pins are concerned.
(V_CC and PLLV_CC are the same
voltage)
Except for the PLLCAP, EXTAL,
XTAL, CK, and H-UDI pins and
the analog input pin
Refer to table 29.2,
Correspondence between Power
Supply Names and Pins
[Operating precautions]
Operating the LSI in excess of the absolute maximum ratings may result in permanent damage.
The two power supply voltages of PV_CC of 5V and V_CC of 3V may be used simultaneously with the LSI. Be sure to use the
LSI in compliance with the connection of power pins, combination conditions of applicable power supply voltages,
voltage applicable to each pin, and conditions of output voltage, as specified in the manual. Connecting a non-specified
power supply or using the LSI at an incorrect voltage may result in permanent damage of the LSI or the system that
contains the LSI.
Note: * Do not apply any power supply voltage to the V_CL pin. Connect to GND through an external capacitor (0.33 to
0.47 μF).
Rev.3.00 Mar. 12, 2008 Page 825 of 948
REJ09B0177-0300