SH7720 Datasheet, PDF (903/1524 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7700 Series

• Data Stage (Control-In)
USB function
IN token reception
Section 25 USB Function Controller (USBF)
Application
From setup stage
1 written
to TRG/EP0s
RDFN?
Yes
No
NAK
Valid data
in EP0i FIFO?
Yes
No
NAK
Data transmission to host
ACK
Set EP0i transmission
complete flag
(IFR0/EP0i TS = 1)
Interrupt request
Write data to EP0i
data register (EPDR0i)
Write 1 to EP0i packet
enable bit
(TRG/EP0i PKTE = 1)
Clear EP0i transmission
complete flag
(IFR0/EP0i TS = 0)
Write data to EP0i
data register (EPDR0i)
Write 1 to EP0i packet
enable bit
(TRG/EP0i PKTE = 1)
Figure 25.7 Data Stage (Control-In) Operation
The application first analyzes command data from the host in the setup stage, and determines the
subsequent data stage direction. If the result of command data analysis is that the data stage is in-
transfer, one packet of data to be sent to the host is written to the FIFO. If there is more data to be
sent, this data is written to the FIFO after the data written first has been sent to the host
(IFR0/EP0i TS = 1).
The end of the data stage is identified when the host transmits an OUT token and the status stage
is entered.
Note:
If the size of the data transmitted by the function is smaller than the data size requested by
the host, the function indicates the end of the data stage by returning to the host a packet
shorter than the maximum packet size. If the size of the data transmitted by the function is
an integral multiple of the maximum packet size, the function indicates the end of the data
stage by transmitting a zero-length packet.
Rev. 3.00 Jan. 18, 2008 Page 841 of 1458
REJ09B0033-0300