UPD78F1502AGK-GAK-AX Datasheet, PDF (491/1031 Pages) Renesas Technology Corp – 16-Bit Single-Chip Microcontrollers

78K0R/Lx3
CHAPTER 14 SERIAL ARRAY UNIT
(2) Operation procedure
Figure 14-25. Initial Setting Procedure for Master Transmission
Starting initial setting
Setting PER0 register
Setting SPSm register
Release the serial array unit from the
reset status and start clock supply.
Set the prescaler.
Setting SMRmn register
Set an operation mode, etc.
Setting SCRmn register
Set a communication format.
Setting SDRmn register
Setting SOm register
Changing setting of SOEm register
Setting port
Writing to SSm register
Starting communication
Set a transfer baud rate.
Manipulate the SOmn and CKOmn bits
and set an initial output level.
Set the SOEmn bit to 1 and enable data
output of the target channel.
Enable data output and clock output of
the target channel by setting a port
register and a port mode register.
Set the SSmn bit of the target channel to
1 to set SEmn = 1.
Set transmit data to the SIOp register (bits
7 to 0 of the SDRmn register) and start
communication.
Caution After setting the SAUmEN to 1, be sure to set the SPSm register after 4 or more clocks have
elapsed.
R01UH0004EJ0501 Rev.5.01
475
Jun 20, 2011