UPD78F1502AGK-GAK-AX Datasheet, PDF (1019/1031 Pages) Renesas Technology Corp – 16-Bit Single-Chip Microcontrollers

78K0R/Lx3
APPENDIX D REVISION HISTORY
Edition
2nd Edition
Description
Modification of Caution 2 in Figure 20-2 Format of Key Return Mode Register
(KRM)
Addition of Table 21-1 Operating Statuses in HALT Mode (3/3)
Modification of Note in Figure 21-3 HALT Mode Release by Interrupt Request
Generation
Modification of Figure 21-4 HALT Mode Release by Reset
Modification of Figure 21-5 Operation Timing When STOP Mode Is Released
(When Unmasked Interrupt Request Is Generated)
Modification of Figure 21-6 STOP Mode Release by Interrupt Request Generation
Modification of Figure 21-7 STOP Mode Release by Reset
Modification of Figure 22-2 Timing of Reset by RESET Input to Figure 22-4
Timing of Reset in STOP Mode by RESET Input
Modification of Table 22-1 Operation Statuses During Reset Period
Modification of Table 22-2 Hardware Statuses After Reset Acknowledgment
Modification of Figure 23-2 Timing of Generation of Internal Reset Signal by
Power-on-Clear Circuit and Low-Voltage Detector
Modification of Caution 1 in Figure 24-2 Format of Low-Voltage Detection
Register (LVIM)
Modification of 24.4.1 When used as reset • When stopping operation
Modification of 24.4.2 When used as interrupt • When stopping operation
Modification of Cautions 1, 2 in Figure 25-1 Format of Regulator Mode Control
Register (RMC)
Modification of Caution 4 in 27.8 Flash Memory Programming by Self-
Programming
Absolute Maximum Ratings
• Modification of Output voltage (VO4), Output current, high (IOH3), Output current,
low (IOL3)
DC Characteristics
• Modification of Output current, high (IOH2), Output current, low (IOL2), Output
voltage, high (VOH2), Output voltage, low (VOL2), Supply current (IDD2), A/D
converter operating current (IADC), Operational amplifier operating current
(IAMP), Voltage reference operating current (IVR), LCD operating current (ILCD2,
ILCD3)
(1) Basic operation in AC Characteristics
• Modification of Instruction cycle
• Addition of Note
• Modification of Minimum instruction execution time during main system clock
operation (FSEL = 0, RMC = 00H) to Minimum instruction execution time
during self programming mode (RMC = 00H)
• Addition of Minimum instruction execution time during self programming
mode (RMC = 5AH)
(2) Serial interface: Serial array unit in AC Characteristics
• Modification of (d) Data hold time (transmission) in During communication at
same potential (simplified I²C mode)
• Modification of (h) Data hold time (transmission) in Communication at different
potential (2.5 V, 3 V) (simplified I²C mode)
(5/14)
Chapter
CHAPTER 20 KEY
INTERRUPT
FUNCTION
CHAPTER 21
STANDBY FUNCTION
CHAPTER 22 RESET
FUNCTION
CHAPTER 23 POWER-
ON-CLEAR CIRCUIT
CHAPTER 24 LOW-
VOLTAGE DETECTOR
CHAPTER 25
REGULATOR
CHAPTER 27 FLASH
MEMORY
CHAPTER 31
ELECTRICAL
SPECIFICATIONS
(TARGET)
R01UH0004EJ0501 Rev.5.01
Jun 20, 2011
1003