UPD78F1502AGK-GAK-AX Datasheet, PDF (358/1031 Pages) Renesas Technology Corp – 16-Bit Single-Chip Microcontrollers

78K0R/Lx3
CHAPTER 6 TIMER ARRAY UNIT
Remarks 1.
2.
3.
78K0R/LF3:
• m = 0, n = 0, 2, p = n+1, q = n+2, TO00 to TO04, and TO07 pins
78K0R/LG3:
• m = 0, n = 0, 2, 4, p = n+1, q = n+2, TO00 to TO07 pins
78K0R/LH3:
• m = 0, n = 0, 2, 4, p = n+1, q = n+2, TO00 to TO07 pins
• m = 1, n = 0, p = 1, q = 2, TO10 to TO13 pins
Figure 6-71. Operation Procedure When Multiple PWM Output Function Is Used (1/2)
TAU
default
setting
Channel
default
setting
Software Operation
Hardware Status
Power-off status
(Clock supply is stopped and writing to each register is
disabled.)
Sets the TAU0EN or TAU1EN bits of the PER0 register
to 1.
Power-on status. Each channel stops operating.
(Clock supply is started and writing to each register is
enabled.)
Sets the TPSm register.
Determines clock frequencies of CKm0 and CKm1.
Sets the TMRmn, TMRmp, and TMRmq registers of
each channel to be used (determines operation mode of
channels).
An interval (period) value is set to the TDRmn register of
the master channel, and a duty factor is set to the
TDRmp and TDRmq register of the slave channel.
Channel stops operating.
(Clock is supplied and some power is consumed.)
Sets slave channel.
The TOMmp and TOMmq bits of the TOMm register
are set to 1 (combination operation mode).
Clears the TOLmp and TOLmq bits to 0.
Sets the TOmp and TOmq bits and determines default
level of the TOmp and TOmq outputs.
Sets TOEmp or TOEmq to 1 and enables operation of
TOmp and TOmq.
Clears the port register and port mode register to 0.
The TOmn pin goes into Hi-Z output state.
The TOmp and TOmq default setting levels are output
when the port mode register is in output mode and the port
register is 0.
TOmp or TOmq does not change because channel stops
operating.
The TOmp and TOmq pins output the TOmp and TOmq
set levels.
Remarks 1.
2.
3.
78K0R/LF3:
• m = 0, n = 0, 2, p = n+1, q = n+2, TO00 to TO04, and TO07 pins
78K0R/LG3:
• m = 0, n = 0, 2, 4, p = n+1, q = n+2, TO00 to TO07 pins
78K0R/LH3:
• m = 0, n = 0, 2, 4, p = n+1, q = n+2, TO00 to TO07 pins
• m = 1, n = 0, p = 1, q = 2, TO10 to TO13 pins
R01UH0004EJ0501 Rev.5.01
342
Jun 20, 2011