HD6432351 Datasheet, PDF (579/989 Pages) Renesas Technology Corp – The H8S/2000 CPU has an internal 32-bit architecture, is provided with sixteen 16-bit general registers and a concise

13.3.2 Operation in Asynchronous Mode
In asynchronous mode, characters are sent or received, each preceded by a start bit indicating the
start of communication and one or two stop bits indicating the end of communication. Serial
communication is thus carried out with synchronization established on a character-by-character
basis.
Inside the SCI, the transmitter and receiver are independent units, enabling full-duplex
communication. Both the transmitter and the receiver also have a double-buffered structure, so
that data can be read or written during transmission or reception, enabling continuous data
transfer.
Figure 13-2 shows the general format for asynchronous serial communication.
In asynchronous serial communication, the transmission line is usually held in the mark state (high
level). The SCI monitors the transmission line, and when it goes to the space state (low level),
recognizes a start bit and starts serial communication.
One serial communication character consists of a start bit (low level), followed by data (in LSB-
first order), a parity bit (high or low level), and finally one or two stop bits (high level).
In asynchronous mode, the SCI performs synchronization at the falling edge of the start bit in
reception. The SCI samples the data on the 8th pulse of a clock with a frequency of 16 times the
length of one bit, so that the transfer data is latched at the center of each bit.
Idle state
(mark state)
1
LSB
MSB
1
Serial _{0 D0 D1 D2 D3 D4 D5 D6 D7 0/1 1}
1
data
Start
bit
Transmit/receive data
Parity Stop bit
bit
1 bit
7 or 8 bits
1 bit, 1 or
or none 2 bits
One unit of transfer data (character or frame)
Figure 13-2 Data Format in Asynchronous Communication
(Example with 8-Bit Data, Parity, Two Stop Bits)
Data Transfer Format: Table 13-10 shows the data transfer formats that can be used in
asynchronous mode. Any of 12 transfer formats can be selected according to the SMR setting.
559