SH7727 Datasheet, PDF (670/1109 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7700 Series

Section 19 Serial Communication Interface with FIFO (SCIF)
In serial reception, the SCIF operates as described below.
1. The SCIF monitors the transmission line, and if a 0 start bit is detected, performs internal
synchronization and starts reception.
2. The received data is stored in SCRSR2 in LSB-to-MSB order.
3. The parity bit and stop bit are received.
After receiving these bits, the SCIF carries out the following checks.
a. Stop bit check: The SCIF checks whether the stop bit is 1. If there are two stop bits, only
the first is checked.
b. The SCIF checks whether receive data can be transferred from the receive shift register 2
(SCRSR2) to SCFRDR2.
c. Break check: The SCIF checks that the BRK flag is 0, indicating that the break state is not
set.
If all the above checks are passed, the receive data is stored in SCFRDR2.
Note: Reception becomes in possible after a receive error occurred.
4. If the RIE bit in SCSCR2 is set to 1 when the RDF or DR flag changes to 1, a receive-FIFO-
data-full interrupt (RXI) request is generated.
If the RIE bit in SCSCR2 is set to 1 when the ER flag changes to 1, a receive-error interrupt
(ERI) request is generated.
If the RIE bit in SCSCR2 is set to 1 when the BRK flag changes to 1, a break reception
interrupt (BRI) request is generated.
Figure 19.10 shows an example of the operation for reception.
Rev. 5.00 Dec 12, 2005 page 598 of 1034
REJ09B0254-0500