SH7727 Datasheet, PDF (624/1109 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7700 Series

Section 18 Smart Card Interface
In the inverse convention type, the logical 1 level is state A, the logical 0 level is state Z, and
communication is MSB first. The start character data is H'3F. The parity bit is even (from the
smart card standards), and thus 0, which corresponds to state Z.
Only data bits D7 to D0 are inverted by the SINV bit. To invert the parity bit, set the O/E bit in
SCSMR to odd parity mode. This applies to both transmission and reception.
(Z) A Z Z A Z Z Z A A Z (Z) State
Ds D0 D1 D2 D3 D4 D5 D6 D7 Dp
a. Direct convention (SDIR, SINV, and O/E are all 0)
(Z) A Z Z A A A A A A Z (Z) State
Ds D7 D6 D5 D4 D3 D2 D1 D0 Dp
b. Inverse convention (SDIR, SINV, and O/E are all 1)
Figure 18.4 Waveform of Start Character
18.3.5 Clock
Only the internal clock generated by the on-chip baud rate generator can be used as the
communication clock in the smart card interface. The bit rate for the clock is set by the bit rate
register (SCBRR) and the CKS1 and CKS0 bits in the serial mode register (SCSMR), and is
calculated using the equation below. Table 18.5 shows sample bit rates. If clock output is then
selected by setting CKE0 to 1, a clock with a frequency 372 times the bit rate is output from the
SCK0 pin.
B=
Pφ
1488 × 2^2n−1 × (N
+
1)
× 10⁶
Where: N = Value set in SCBRR (0 ≤ N ≤ 255)
B = Bit rate (bit/s)
Pφ = Peripheral module operating frequency (MHz)
n = 0 to 3 (table 18.4)
Rev. 5.00 Dec 12, 2005 page 552 of 1034
REJ09B0254-0500