SH7706 Datasheet, PDF (659/749 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH™ RISC engine Family/SH7700 Series

Section 24 Electrical Characteristics
Item
Symbol Min Typ Max Unit Measurement Conditions
Analog
power-
supply
current
During A/D AIcc
conversion
During A/D
and D/A
conversion
—
0.8 2
mA
—
2.4 6
mA
Idle
—
0.01 5.0 µA Ta = 25°C
Notes: Regardless of whether PLL or RTC is used, connect Vcc – PLL and Vcc – RTC to Vcc, and
Vss – PLL and Vss – RTC to Vss.
AVcc must be under condition of VccQ – 0.3 V ≤ AVcc ≤ VccQ + 0.3 V. If the A/D and D/A
converters are not used, do not leave the AVcc and AVss pins open. Connect AVcc to
VccQ, and connect AVss to VssQ.
Current dissipation values shown are the values at which all output pins are without load
under conditions of V_IHmin = VccQ – 0.5 V, V_ILmax = 0.5 V.
1. No external bus cycles except refresh cycles.
2. Total current of Vcc, Vcc – PLL1, and Vcc – PLL2
3. Current of VccQ
4. Current of Vcc – RTC
5. Only in software standby mode
Table 24.3 Permitted Output Current Values
Conditions: VccQ = 3.3 ± 0.3 V, Vcc = 1.9 ± 0.15 V, AVcc = 3.3 ± 0.3 V, Ta = –20 to +75°C
Item
Symbol Min Typ Max Unit
Output low-level permissible current (per pin)
I
OL
—
—
2.0 mA
Output low-level permissible current (total)
∑ I_OL
—
—
120 mA
Output high-level permissible current (per pin)
–I_OH
—
—
2.0 mA
Output high-level permissible current (total)
∑ (–I ) —
—
40
mA
OH
Caution: To ensure LSI reliability, do not exceed the value for output current given in Table 24.3.
Rev. 5.00 May 29, 2006 page 611 of 698
REJ09B0146-0500