SH7080_09 Datasheet, PDF (647/1622 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family

Section 11 Multi-Function Timer Pulse Unit 2 (MTU2)
3. Buffer Transfer Control Linked with Interrupt Skipping
In complementary PWM mode, whether to transfer data from a buffer register to a temporary
register and whether to link the transfer with interrupt skipping can be specified with the BTE1
and BTE0 bits in the timer buffer transfer set register (TBTER).
Figure 11.76 shows an example of operation when buffer transfer is suppressed (BTE1 = 0 and
BTE0 = 1). While this setting is valid, data is not transferred from the buffer register to the
temporary register.
Figure 11.77 shows an example of operation when buffer transfer is linked with interrupt
skipping (BTE1 = 1 and BET0 = 0). While this setting is valid, data is not transferred from the
buffer register outside the buffer transfer-enabled period.
Note that the buffer transfer-enabled period depends on the T3AEN and T4VEN bit settings in
the timer interrupt skipping set register (TITCR). Figure 11.78 shows the relationship between
the T3AEN and T4VEN bit settings in TITCR and buffer transfer-enabled period.
Note:
This function must always be used in combination with interrupt skipping.
When interrupt skipping is disabled (the T3AEN and T4VEN bits in the timer interrupt
skipping set register (TITCR) are cleared to 0 or the skipping count set bits (3ACOR and
4VCOR) in TITCR are cleared to 0), make sure that buffer transfer is not linked with
interrupt skipping (clear the BTE1 bit in the timer buffer transfer set register (TBTER) to
0). If buffer transfer is linked with interrupt skipping while interrupt skipping is disabled,
buffer transfer is never performed.
Rev. 4.00 Dec. 15, 2009 Page 587 of 1558
REJ09B0181-0400