SH7080_09 Datasheet, PDF (629/1622 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family

Section 11 Multi-Function Timer Pulse Unit 2 (MTU2)
11. Complementary PWM Mode 0% and 100% Duty Output
In complementary PWM mode, 0% and 100% duty cycles can be output as required. Figures
11.49 to 11.53 show output examples.
100% duty output is performed when the data register value is set to H'0000. The waveform in
this case has a positive phase with a 100% on-state. 0% duty output is performed when the
data register value is set to the same value as TGRA_3. The waveform in this case has a
positive phase with a 100% off-state.
On and off compare-matches occur simultaneously, but if a turn-on compare-match and turn-
off compare-match for the same phase occur simultaneously, both compare-matches are
ignored and the waveform does not change.
12. Toggle Output Synchronized with PWM Cycle
In complementary PWM mode, toggle output can be performed in synchronization with the
PWM carrier cycle by setting the PSYE bit to 1 in the timer output control register (TOCR).
An example of a toggle output waveform is shown in figure 11.54.
This output is toggled by a compare-match between TCNT_3 and TGRA_3 and a compare-
match between TCNT4 and H'0000.
The output pin for this toggle output is the TIOC3A pin. The initial output is 1.
TGRA_3
H'0000
Toggle output
TIOC3A pin
TCNT_4
TCNT_3
Figure 11.54 Example of Toggle Output Waveform Synchronized with PWM Output
Rev. 4.00 Dec. 15, 2009 Page 569 of 1558
REJ09B0181-0400