SH7080_09 Datasheet, PDF (1313/1622 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family

Section 23 Flash Memory
(1) SCI Interface Setting by Host
When boot mode is initiated, this LSI measures the low period of asynchronous SCI-
communication data (H'00), which is transmitted consecutively by the host. The SCI
transmit/receive format is set to 8-bit data, 1 stop bit, and no parity. This LSI calculates the bit
rate of transmission by the host by means of the measured low period and transmits the bit
adjustment end sign (1 byte of H'00) to the host. The host must confirm that this bit adjustment
end sign (H'00) has been received normally and transmits 1 byte of H'55 to this LSI. When
reception is not executed normally, boot mode is initiated again (reset) and the operation
described above must be executed. The bit rate between the host and this LSI is not matched
because of the bit rate of transmission by the host and system clock frequency of this LSI. To
operate the SCI normally, the transfer bit rate of the host must be set to 9,600 bps or 19,200
bps.
The system clock frequency which can automatically adjust the transfer bit rate of the host and
the bit rate of this LSI is shown in table 23.8. Boot mode must be initiated in the range of this
system clock. Note that the internal clock division ratio of ×1/3 is not supported in boot mode.
Start _{D0 D1 D2 D3 D4 D5 D6}
bit
Measure low period (9 bits) (data is H'00)
D7 ^{Stop bit}
High period of
at least 1 bit
Figure 23.7 Automatic Adjustment Operation of SCI Bit Rate
Table 23.8 Peripheral Clock (Pφ) Frequency that Can Automatically Adjust Bit Rate of
This LSI
Host Bit Rate
Peripheral Clock (Pφ) Frequency Which Can Automatically Adjust LSI's
Bit Rate
9,600 bps
10 to 40 MHz
19,200 bps
10 to 40 MHz
Note: The internal clock division ratio of ×1/3 is not supported in boot mode.
Rev. 4.00 Dec. 15, 2009 Page 1253 of 1558
REJ09B0181-0400