SH7080_09 Datasheet, PDF (1312/1622 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family

Section 23 Flash Memory
23.5 On-Board Programming Mode
When the pin is set in on-board programming mode and the reset start is executed, the on-board
programming state that can program/erase the on-chip flash memory is entered. On-board
programming mode has three operating modes: user program mode, user boot mode, and boot
mode.
For details on the pin setting for entering each mode, see table 23.1. For details on the state
transition of each mode for flash memory, see figure 23.2.
23.5.1 Boot Mode
Boot mode executes programming/erasing user MAT and user boot MAT by means of the control
command and program data transmitted from the host using the on-chip SCI. The tool for
transmitting the control command and program data must be prepared in the host. The SCI
communication mode is set to asynchronous mode. When reset start is executed after this LSI's pin
is set in boot mode, the boot program in the microcomputer is initiated. After the SCI bit rate is
automatically adjusted, the communication with the host is executed by means of the control
command method.
The system configuration diagram in boot mode is shown in figure 23.6. For details on the pin
setting in boot mode, see table 23.1. Interrupts are ignored in boot mode, so do not generate them.
Note that the AUD cannot be used during boot mode operation.
This LSI
Host
Boot
programming
tool and program
data
Control command, program data
Reply response
Control command,
analysis execution
software (on-chip)
RXD1
On-chip SCI1
TXD1
Flash
memory
On-chip RAM
Figure 23.6 System Configuration in Boot Mode
Rev. 4.00 Dec. 15, 2009 Page 1252 of 1558
REJ09B0181-0400