SH7785 Datasheet, PDF (936/1692 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer

19. Display Unit (DU)
19.3.39 Plane n Display Area Start Address 1 Register (PnDSA1R) (n = 1 to 6)
The plane n display area start address 1 registers (PnDSA1R, n = 1 to 6) set the memory area in
frame buffer 1 for plane n. The value is retained during power-on reset and manual reset.
Bit: 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
PnDSA1
Initial value: — — — — — — — — — — — — — — — —
R/W: R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W
Internal update: O O O O O O O O O O O O O O O O
Bit: 15 14 13 12 11 10 9
8
7
6
5
4
3
2
1
0
PnDSA1
————
Initial value: — — — — — — — — — — — — 0
0
0
0
R/W: R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R R R R
Internal update: O O O O O O O O O O O O
Bit
31 to 4
3 to 0
Initial
Bit Name Value R/W
PnDSA1 Undefined R/W
⎯
All 0
R
Internal
Update Description
Yes
Plane n Display Area Start Address 1
To enable the 31 to 29 bits, the DSAE bit in
DEFR should be set to 1.
In the initial state the bits are not enabled, and
are fixed at 0.
When the buffer mode for plane n is manual
display change mode or auto display change
mode, the buffer is used as frame buffer 1.
Note: In 32-bit address extended mode, when
the 31 to 29 bits in this register are
disabled, of the lower 29 bits of a specified
32-bit physical address, a 25-bit address
(A28 to A4) is specified in the 28 to 4 bits.
⎯
Reserved
These bits are always read as 0. The write value
should always be 0.
Rev.1.00 Jan. 10, 2008 Page 906 of 1658
REJ09B0261-0100