SH7785 Datasheet, PDF (580/1692 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer

12. DDR2-SDRAM Interface (DBSC2)
12.5.13 Regarding MCKE Signal Operation
The MCKE signal operation is explained using figure 12.24. Here, the explanation assumes that
MBKPRST is high-level input. Prior to power-on reset the MCKE signal is indefinite, but upon
power-on reset is output at low level. After release of power-on reset, by writing 011 to the CMD
bits in the SDRAM command control register (DBCMDCNT), the MCKE signal output is at high
level, corresponding to the enable state. Once the MCKE signal is output at a high level in this
way, the DBSC2 does not output a low-level MCKE signal except when causing a transition to
self-refresh state. (Once the CMD bits in DBCMDCNT are set to 011, no matter what value is
subsequently written to CMD, the MCKE signal is never output at low level.) After the transition
to self-refresh state, when 0 is written to SRFEN in DBRFCNT0 to release the self-refresh state,
the MCKE signal output returns to high level.
MCKE _Undefined
Power-on reset
Power-on reset canceled
011 is written to the CMD2 to CMD0 bits
in DBCMDCNT.
The SRFEN bit in DBRFCNT0 is set to
1 (transition to self-refresh state).
The SRFEN bit in DBRFCNT0 is cleared to
0 (release of self-refresh state).
Figure 12.24 MCKE Signal Operation
Rev.1.00 Jan. 10, 2008 Page 550 of 1658
REJ09B0261-0100