SH7785 Datasheet, PDF (482/1692 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer

11. Local Bus State Controller (LBSC)
11.5.14 Mode Pin Settings and General Input Output Port Settings about Data Bus Width
Table 11.18 shows the examples of MODE pin settings and port settings (GPIO port control
register) related to the selection of the data bus width used in the local bus.
Table 11.18 MODE Pin Settings and Port Settings Related to Data Bus Width Selection
Data Bus
Width Data Pins MODE12 MODE11 PACR
GPIO Port Control Register
PBCR PCCR PDCR PFCR
64 bits D63 to D0 H
L
H'0000 H'0000 H'0000 H'0000 H'0000
32 bits D31 to D0 Any
Any
Any
Any
Any
Any
H'0000
16 bits D16 to D0
Any
Any
Any
Any
Any
8 bits D7 to D0
Any
Any
Any
Any
Any
Legend:
L: Low level
H: High level
Note: Concerning "any", setting should be correspondent to the system.
PGCR
H'0000
H'0000
Any
Any
11.5.15 Pins Multiplexed with Other Modules Functions
Some pins used by the LBSC are multiplexed with general input output port (GPIO) and functions
used in other peripheral modules. The pins to be used by the LBSC should start access after setting
these pins to the LBSC functions with GPIO register. For example, when PCMCIA interface is
used, the functions of CE2A and CE2B should be enabled with the GPIO bit in PIMSELR and the
GPIO bit in PLCR before starting access.
11.5.16 Register Settings for Divided-Up DACKn Output
When the access size of DMAC1 transfer related to the local bus space is larger than the data bus
width, multiple bus cycles are generated. When multiple bus cycles are generated and CS is
negated between bus cycles, DACKn output is divided up, in the same way as CS.
Tables 11.19 to 11.22 shows the register settings when DACKn output is not divided up in DMA1
transfer and when it is divided up.
Rev.1.00 Jan. 10, 2008 Page 452 of 1658
REJ09B0261-0100