307013-003 Datasheet, PDF (793/848 Pages) Intel Corporation – Intel I/O Controller Hub 7

Electrical Characteristics
Table 23-4. DC Characteristic Input Signal Association (Sheet 2 of 2)
Symbol
V_IH11/V_IL11
Associated Signals
AC ’97/Intel^® High Definition Audio Signals: ACZ_SDIN[2:0],
Mobile Only: AZ_DOCK_RST#/GPIO34
AC ‘97 Signals: ACZ_BIT_CLK
Strap Signals: ACZ_SDOUT, ACZ_SYNC (Strap purposes only)
GPIO Signals: GPIO34 (Desktop Only)
NOTE: See V_{IL_HDA}/V_{IH_HDA} for High Definition Audio Low Voltage Mode
(Mobile/Ultra Mobile Only)
V_IH12/V_IL12^/
V_cross(abs)
V_IH13/V_IL13
Clock Signals: DMI_CLKN, DMI_CLKP, SATA_CLKN, SATA_CLKP
Power Management Signals:
Desktop Only: PWRBTN#, RI#, SYS_RESET#, WAKE#
Mobile/Ultra Mobile Only: BATLOW#, PWRBTN#, RI#, SYS_RESET#,
WAKE#
System Management Signal: LINKALERT#
Intel^® Quick Resume Technology Signals: EL_STATE[1:0]/GPIO[28:27],
EL_RSVD/GPIO26 (ICH7DH Only)
GPIO Signals: GPIO[28:26, 25:24, 15:12, 10:8]
Other Signals: TP0
V_IH14/V_IL14
Power Management Signals: PWROK, RSMRST#, RTCRST#
System Management Signals: INTRUDER#
V_IH15/V_IL15
V+/V-/V_HYS/
V_THRAVG/V_RING
(5V Tolerant)
V_DI / V_CM / V_SE
(5V Tolerant)
Other Signals: INTVRMEN (Desktop and Mobile Only)
IDE Signals: DD[15:0], DDREQ, IORDY,
For Ultra DMA Mode 4 and lower these signals follow the DC characteristics
for V_IH2/V_IL2
USB Signals: USBP[7:0][P,N] (Low-speed and Full-speed)
V_HSSQ / V_HSDSC /
V_HSCM
(5V Tolerant)
V_{IH_HDA} / V_{IL_HDA}
(Mobile/Ultra
Mobile Only)
USB Signals: USBP[7:0][P,N] (in High-speed Mode)
Intel^® High Definition Audio Signals: ACZ_SDIN[2:0],
AZ_DOCK_RST#/GPIO34
NOTE: Only applies when running in Low Voltage Mode (1.5 V)
Intel ^® ICH7 Family Datasheet
793