SH7055S Datasheet, PDF (226/1002 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7000 Series

Table 10.8 Transfer Conditions and Register Set Values for Transfer between External
Memory and SCI1 Transmitting Side
Transfer Conditions
Transfer source: external memory
Value stored in address H'00400000
Value stored in address H'00450000
Transfer destination: on-chip SCI TDR1
Transfer count: 10 times
Transfer source address: incremented
Transfer destination address: fixed
Transfer request source: SCI1 (TDR1)
Bus mode: cycle-steal
Transfer unit: byte
Interrupt request not generated at end of transfer
DMAC master enable on
Register
SAR3
—
—
DAR3
DMATCR3
CHCR3
DMAOR
Value
H'00400000
H'00450000
H'55
H'FFFFF00B
H'0000000A
H'10031001
H'0001
When indirect address mode is on, the data stored in the address set in SAR is not used as the
transfer source data. In the case of indirect addressing, the value stored in the SAR address is read,
then that value is used as the address and the data read from that address is used as the transfer
source data, then that data is stored in the address designated by DAR.
In the table 10.8 example, when a transfer request from TDR1 of SCI1 is generated, a read of the
address located at H'00400000, which is the value set in SAR3, is performed first. The data
H'00450000 is stored at this H'00400000 address, and the DMAC first reads this H'00450000
value. It then uses this read value of H'00450000 as an address and reads the value of H'55 that is
stored in the H'00450000 address. It then writes the value H'55 to address H'FFFFF00B designated
by DAR3 to complete one indirect address transfer.
With indirect addressing, the first executed data read from the address set in SAR3 always results
in a longword size transfer regardless of the TS0 and TS1 bit designations for transfer data size.
However, the transfer source address fixed and increment or decrement designations are according
to the SM0 and SM1 bits. Consequently, despite the fact that the transfer data size designation is
byte in this example, the SAR3 value at the end of one transfer is H'00400004. The write operation
is exactly the same as an ordinary dual address transfer write operation.
Rev.2.0, 07/03, page 188 of 960