 English |
|
|
|
|
|
|
|
| MC9S12XD256MAL Datasheet, PDF (580/1348 Pages) Freescale Semiconductor, Inc – Freescale’s Scalable Controller Area Network | |||
| |||
| ◁ |
Chapter 15 Background Debug Module (S12XBDMV2)
Table 15-5. Hardware Commands
Command
Opcode
(hex)
Data
Description
BACKGROUND
90
None
Enter background mode if ï¬rmware is enabled. If enabled, an ACK will be
issued when the part enters active background mode.
ACK_ENABLE
D5
None
Enable Handshake. Issues an ACK pulse after the command is executed.
ACK_DISABLE
D6
None
Disable Handshake. This command does not issue an ACK pulse.
READ_BD_BYTE
E4 16-bit address Read from memory with standard BDM ï¬rmware lookup table in map.
16-bit data out Odd address data on low byte; even address data on high byte.
READ_BD_WORD
EC 16-bit address Read from memory with standard BDM ï¬rmware lookup table in map.
16-bit data out Must be aligned access.
READ_BYTE
E0 16-bit address Read from memory with standard BDM ï¬rmware lookup table out of map.
16-bit data out Odd address data on low byte; even address data on high byte.
READ_WORD
E8 16-bit address Read from memory with standard BDM ï¬rmware lookup table out of map.
16-bit data out Must be aligned access.
WRITE_BD_BYTE
C4 16-bit address Write to memory with standard BDM ï¬rmware lookup table in map.
16-bit data in Odd address data on low byte; even address data on high byte.
WRITE_BD_WORD CC 16-bit address Write to memory with standard BDM ï¬rmware lookup table in map.
16-bit data in Must be aligned access.
WRITE_BYTE
C0 16-bit address Write to memory with standard BDM ï¬rmware lookup table out of map.
16-bit data in Odd address data on low byte; even address data on high byte.
WRITE_WORD
C8 16-bit address Write to memory with standard BDM ï¬rmware lookup table out of map.
16-bit data in Must be aligned access.
NOTE:
If enabled, ACK will occur when data is ready for transmission for all BDM READ commands and will occur after the write is
complete for all BDM WRITE commands.
15.4.4 Standard BDM Firmware Commands
Firmware commands are used to access and manipulate CPU resources. The system must be in active
BDM to execute standard BDM ï¬rmware commands, see Section 15.4.2, âEnabling and Activating
BDMâ. Normal instruction execution is suspended while the CPU executes the ï¬rmware located in the
standard BDM ï¬rmware lookup table. The hardware command BACKGROUND is the usual way to
activate BDM.
As the system enters active BDM, the standard BDM ï¬rmware lookup table and BDM registers become
visible in the on-chip memory map at 0x7FFF00â0x7FFFFF, and the CPU begins executing the standard
BDM ï¬rmware. The standard BDM ï¬rmware watches for serial commands and executes them as they are
received.
The ï¬rmware commands are shown in Table 15-6.
MC9S12XDP512 Data Sheet, Rev. 2.21
580
Freescale Semiconductor
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese