MC9S12XD256MAL Datasheet, PDF (1253/1348 Pages) Freescale Semiconductor, Inc – Freescale’s Scalable Controller Area Network

Appendix A Electrical Characteristics
A.2.2.3 Current Injection
There are two cases to consider.
1. A current is injected into the channel being converted. The channel being stressed has conversion
values of $3FF ($FF in 8-bit mode) for analog inputs greater than V_RH and $000 for values less
than V_RL unless the current is higher than specified as disruptive condition.
2. Current is injected into pins in the neighborhood of the channel being converted. A portion of this
current is picked up by the channel (coupling ratio K), This additional current impacts the accuracy
of the conversion depending on the source resistance.
The additional input voltage error on the converted channel can be calculated as:
V_ERR = K * R_S * I_INJ
with I_INJ being the sum of the currents injected into the two pins adjacent to the converted channel.
Table A-14. ATD Electrical Characteristics
Conditions are shown in Table A-4 unless otherwise noted
Num C
Rating
Symbol
Min
Typ
Max
Unit
1 C Max input source resistance
2 T Total input capacitance
Non sampling
Sampling
3 C Disruptive analog input current¹
4 C Coupling ratio positive current injection
5 C Coupling ratio negative current injection
1 _{See also Table A-7. item 14}
R_S
—
—
1
KΩ
pF
C_INN
—
—
10
C_INS
—
—
22
I_NA
–2.5
—
2.5
mA
K_p
—
—
10^-4
A/A
K_n
—
—
10^-2
A/A
Freescale Semiconductor
MC9S12XDP512 Data Sheet, Rev. 2.21
1255