|
HD64F2638F20J Datasheet, PDF (955/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series | |||
|
◁ |
H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
Section 22A Clock Pulse Generator
(H8S/2636 Group, H8S/2638 Group, H8S/2630 Group)
Bit 3âFrequency Multiplication Factor Switching Mode Select (STCS): Selects the operation
when the PLL circuit frequency multiplication factor is changed.
Bit 3
STCS
Description
0
Specified multiplication factor is valid after transition to software standby mode,
watch mode*, and subactive mode*
(Initial value)
1
Specified multiplication factor is valid immediately after STC bits are rewritten
Note: * Subclock functions (subactive mode, subsleep mode, and watch mode) are available in the
U-mask and W-mask versions only.
These functions cannot be used with the other versions.
Bits 2 to 0âSystem Clock Select 2 to 0 (SCK2 to SCK0): These bits select the bus master
clock.
Bit 2
SCK2
0
1
Bit 1
SCK1
0
1
0
1
Bit 0
SCK0
0
1
0
1
0
1
â
Description
Bus master is in high-speed mode
Medium-speed clock is Ï/2
Medium-speed clock is Ï/4
Medium-speed clock is Ï/8
Medium-speed clock is Ï/16
Medium-speed clock is Ï/32
â
(Initial value)
22A.2.2 Low-Power Control Register (LPWRCR)
Bit
Initial value
Read/Write
7
6
5
4
3
2
DTON LSON NESEL SUBSTP RFCUT â¯
0
0
0
0
0
0
R/W
R/W
R/W
R/W
R/W
R/W
1
STC1
0
R/W
0
STC0
0
R/W
LPWRCR is an 8-bit readable/writable register that performs power-down mode control. The
following pertains to bits 1 and 0. For details of the other bits, see section 23A.2.3, 23B.2.3, Low
Power Control Register (LPWRCR). LPWRCR is initialized to H'00 by a reset and in hardware
standby mode. It is not initialized in software standby mode.
REJ09B0103-0800 Rev. 8.00
May 28, 2010
Page 905 of 1458
|
▷ |