HD64F2638F20J Datasheet, PDF (254/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 8 Data Transfer Controller (DTC)
H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
8.3.3 DTC Vector Table
Figure 8-4 shows the correspondence between DTC vector addresses and register information.
Table 8-4 shows the correspondence between activation and vector addresses. When the DTC is
activated by software, the vector address is obtained from: H'0400 + (DTVECR[6:0] << 1) (where
<< 1 indicates a 1-bit left shift). For example, if DTVECR is H'10, the vector address is H'0420.
The DTC reads the start address of the register information from the vector address set for each
activation source, and then reads the register information from that start address. The register
information can be placed at predetermined addresses in the on-chip RAM. The start address of
the register information should be an integral multiple of four.
The configuration of the vector address is the same in both normal* and advanced modes, a 2-byte
unit being used in both cases. These two bytes specify the lower bits of the address in the on-chip
RAM.
Note: * Not available in the chip.
DTC vector
address
Register information
start address
Register information
Chain transfer
Figure 8-4 Correspondence between DTC Vector Address and Register Information
Page 204 of 1458
REJ09B0103-0800 Rev. 8.00
May 28, 2010